Sanyo CLT-OHE40 User Manual

Page 4

–

Step 2: Register the Handset

YOU NEED TO REGISTER THE CLT-OHE40 TO A MAIN BASE BEFORE
USE!

Be sure the handset battery is fully charged.

With the main base in standby mode (i.e., not being used), place
the handset in the main base to begin registration.

For compatible models in the CLT-E23 and CLT-E30/32/33
series:
1)Disconnect the AC adapter.
2)While holding the find handset key, connect the AC Adapter:

Keep pressing the key until the CHARGE LED starts to blink.

3)On the handset, press and hold # until you hear beep.

H an d se t R e gi s te ri n g

will appear in the LCD. Once

R eg i st r at i on Co mp l et e

is displayed, the extra handset is

registered to the base. If

Re g is t ra ti o n Fa i le d

appears, please

try these steps again.

De-register the handset

1)Press and hold END and # for more than 5 seconds.
2)Select the handset ID to be de-registered from the list.
The phone will ask you to confirm the deregistration. Select

Y e s

UU438DH_ENG.fm Page 4 Monday, June 13, 2005 7:00 PM