Sunbeam MG6500 - Manual (Page 8)

8
Using your Cordless
Beard Trimmer & Shaper
Using for the first time
• The appliance must be fully charged before using for the
first time.
• To reach the optimum recharge capacity, the batteries
should be charged for 8.5 hours. Do not charge for longer
than this time.
• Ensure that the Beard Trimmer & Shaper is switched off by
pushing down the on / off switch.
• Insert the charger lead into the charging stand and place the
Beard Trimmer & Shaper firmly into the slot location
• Plug the adaptor into a suitable mains outlet and switch on.
• The red light on the appliance will light up and will switch
to green when charging is completed.
• The Beard Trimmer & Shaper will work for approximately 35
minutes on full charge.
• Recharging after each use is not needed if the 35 minute
working period has not been fully used.
• It is not possible to use this appliance when the adaptor is
plugged into the mains.
Note: Do not charge for longer than the recommended
time of 8.5 hours.
Using the nose & ear hair trimmer
• Attach the nose hair trimmer attachment by placing on the
unit and turning clockwise until it clicks into place.