Sunbeam PU4800 - Manual (Page 9)

9
Using your Straightener
Using your straightener
• Insert the plug into the power outlet and
turn the power on.
• Move the on/off switch to the on position
(I)
• Select the desired heat level by rotating
the temperature dial on the side of the
straightener. Use lower heat for fine hair or
touch ups. Use higher heat for thicker hair
or more resistant curls.
• Allow the straightener to heat up for a few
moments before using.
• Brush hair thoroughly. Separate out section
of hair approximately 4cm in width and
smooth it with a comb.
• For best results start at the scalp and work
to the ends of the hair. Place the separated
section of hair between the flat plates and
close the handle around the hair.
• Hold the styler in position for 3 to 5
seconds depending on the hair type.
• Once the hair is heated, carefully slide the
styler along the section of separated hair,
making sure that the hair is heated and
straightened all the way to the ends.
• Select another section of hair and repeat
the process.
• Use the cool shot setting on the hairdryer
to set the style.