Sirius Satellite Radio Sportster SP-C1 User Manual
Page 6
Sportster SP-C1 User Guide
6
Installation in a Vehicle: Mounting the Antenna
1. Temporarily plug the antenna into the
“ANT” connector on the back of the cradle
until it is firmly seated.
2. Find a location on a metal surface of your
vehicle at least 12" x 12", and at least 6"
from a window.
3. The antenna’s powerful magnet will secure
it to the metal surface. Before routing the
antenna cable, confirm that the antenna is
mounted in a good location.
4. Temporarily plug the Car Power Adapter into the
cigarette lighter.
5. Make sure the lock lever on the back of the cradle is in
the UNLOCK position. Slide the SP-R1 Receiver all
the way into the cradle so that the connector at the
bottom of the unit makes proper contact in the cradle.
Move the lock lever to the LOCK position. Press and
hold the POWER button to turn the SP-R1 Receiver
on.
6. If your SP-R1 Receiver has been properly connected
and the antenna is receiving the SIRIUS signal you
will hear audio. If you do not hear audio and the
display shows “Acquiring Signal”, reposition the
antenna until the message goes away and you hear
audio. (See Antenna Signal, on page 21 of the SP-R1
Receiver manual to use the ANTENNA SIGNAL
screen to aim the antenna.)
• Make sure the vehicle is not in garage, or somewhere
the satellite signal could be blocked.
• Best reception is achieved with the antenna mounted
on the roof or the trunk for convertibles.
• If the vehicle has a roof rack or skid ribs, it may be
necessary to mount the antenna off-center.