Seiko H801 - Manual (Page 6)

4. Press “B” to show the TIME/CALENDAR SETTING display. To
return to the CALENDAR display, press “A”.
* If the watch is left untouched with digits flashing, the display
will automatically return to the CALENDAR display after 1 to
2 minutes.
ANALOGUE TIME SETTING
1. Pull out the crown when the second hand is at the 12 o’clock
position.* The second hand stops on the spot.
* If the crown is of the screw lock type, unscrew the crown by
turning it counterclockwise, and then pull it out.
2. Turn the crown to set the desired hour and minutes. When
setting the minute hand, advance it a few minutes ahead and
then turn it back to the exact time.
3. Push the crown back in to the normal position in accordance
with a time signal.*
* If the crown is of the screw lock type, screw it in completely
by turning it clockwise while pressing it.
• Before setting the analogue time, be sure to set the digital time.
Notes: 1. When the flashing SECONDS digits read any number from “30” to “59” and
“A” is pressed, one minute is added.
2. When setting the HOUR, check that AM/PM is set properly in the 12-hour
indication. Only “P” (PM) is displayed. For the AM setting, there is no
indication.
3. When the digital time is set in the 24-hour indication, the alarm time will also
be displayed in the 24-hour indication. Crown