Shark UV610 - Manual (Page 3)

HOW TO OPERATE YOUR CORDLESS SWEEPER
CLEANING THE DUST CONTAINER
1. Before using, please ensure that the cordless sweeper has been initially
charged for 16-20 hours
Your cordless sweeper will only operate properly when the batteries are fully
charged. When fully charged your sweeper will operate for 35-45 minutes -
dependent upon the type of use (example - carpets or bare floors).
2. Push the On/Off switch to operate the unit. To turn off , press switch again.(Fig.4)
NOTE: Do not operate the sweeper without the dust container in place.
To achieve the best performance, empty the dust container after each use.
1. Pull the dust container straight out from the side. (Fig. 6)
Fig. 7
2. Empty dust container contents. (Fig. 7) If desired- you may rinse with water to
clean the dust container - but dry thoroughly before replacing on the sweeper.
Fig. 8
3. Replace dust container on cordless sweeper.
4. Periodically remove the transparent brush cover on the front of the cordless
sweeper and remove any build up of lint, hair or fiber on the rotating brush. To
remove the cover - grip the cover from the bottom, pull out and upward until
the cover unlocks from the side slots and tabs located on the top of the
sweeper. (Fig. 8)
Fig. 8
CAUTION:
Do not accidentally turn unit on while cleaning. Do not
clean while unit is charging.
Fig. 6
Fig. 7
“On/Off” switch
Fig. 4
CAUTION:
Any electronic or electrical appliance
should not be stored in or exposed to
areas of high heat or humidity. Do not store
your cordless sweeper close to stoves,
radiators, furnaces or in a bathroom or bathing
area.
3. To release the handle to a comfortable position, apply pressure to the top of
the sweeper head with your foot while pulling back on the handle.(Fig. 5)
Fig. 5
4
5