SIIG 04-0680B User Manual
Page 5
5
2.
Install the Vesa Plate with Arm (c) to the
tube support, make sure the wire clips are
on the bottom. Tighten the clamp bolt using
the Allen Key (j).
Caution: When installing the VESA Plate
with Arm (c), DO NOT over tighten the
clamp bolt. The VESA Plate with Arm is
intended to rotate (360 degrees) and is not
meant to be attached in a fixed position.
Tighten the bolt only tight enough to keep
the VESA Plate with Arm at the desired
height position. Over tightening the bolt
may result in damage to the clamp.