Stow Nighthawk Dedicated Light Tower LT-12D - Manual (Page 27)

LT-12 SERIES LIGHT TOWER — OPERATION MANUAL — REV. #1 (08/15/08) — PAGE 27
LT-12 SERIES LIGHT TOWER — INSPECTION
The engine's exhaust contains harmful
emissions. ALWAYS ventilate the exhaust
when operating inside tunnels, excavations
or buildings. Direct exhaust away from
nearby personnel.
Before starting the engine perform the following:
1. Be sure to disconnect the electrical load and switch the
main circuit breaker and all lamp (4) circuit breakers to the
OFF position prior to starting the engine.
2. NEVER start the engine with any circuit breakers in the ON
position.
3. Make sure light tower is placed on secure level ground
with chock blocks underneath each wheel to prevent the
light tower from rolling.
4. Outriggers have been fully extended to prevent the trailer
from tipping.
5. All tower mast sections have been raised to the desired
height.
6. Bottom tower mast is locked in place.
7. Light tower trailer support stands have been positioned
properly and the trailer is level.
8. Flood lights have been adjusted to desired position.
9. Chocked blocks have been positioned under each wheel to
prevent trailer from rolling.
10. Flood lights DO NOT interfere with any overhead
obstructions.
11. Flood light power cables have been plugged into the
appropriate receptacles (J1-J4) on the T-Bar assembly.
12. Light tower trailer frame has been grounded correctly.
DO NOT attempt to start the engine
until all the conditions referenced
in steps 1 through 12 have been
met.
NOTE
WARNING - Respiratory Hazard
ALWAYS make sure the area
above Light tower is open and
clear of overhead power lines
and other obstructions. The
tower extends in excess of 30
ft. (9 meters). Contact with
overhead powerlines or other
obstructions could result in
equipment damage,
Serious
Injury or Death !
DANGER - Overhead Obstruction Danger