Skylink MULTI LINK PRO ML-001 - Manual (Page 20)

OPERATION
Note:
- Each zone can program up to 2 sensors. There are 5 zones, so up to 10 sensors
can be programmed to the control panel. Please refer to page 37, "Sensor
Location Selection Guide" for detail information.
Alert Mode Examples (Door/Window sensor sold separately)
Note:
-For Door / Window sensor, alert notification (beeping and LED flashing) will
continue until the sensor is in closed position, i.e. closing the window or door.
-For Motion Sensor, the alert notification (beeping and LED flashing) will last for 20
seconds for every detected movement.
The Control Panel is always in one of the 2 operating modes:
1. Alert Mode - When the system is not armed (ARM LED off), it is in alert mode.
2. Alarm Mode - When the system is armed (ARM LED on), it is in alarm mode.
The Control Panel will be in alert mode automatically if the system is not armed.
Alert mode allows users inside the premises to know what sensor is triggered.
It is intended to be used when someone stays inside the premises.
In alert mode, the control panel will give you notification of the triggered sensor(s)
by voice announcement, unique beeping and LED flashing.
1 Number of beeps Zone of the triggered sensor
2 Number of flashes of zone LED Sensor number of the triggered sensor
3 Voice announcement Tells you the zone and locations of
the triggered sensor by human voice.
Alert Mode
3. Double flash 1. Zone 3
Sensor 2
Triggered
3. Single flash
1. Zone 1
Sensor 1
Triggered
2.
Beep___Beep___
Beep___Beep .....
Zone 1 Sensor 1
door open
Zone 3 Sensor 2 window
open
2.
Beep Beep Beep___
Beep Beep Beep___
– 18 –
ADVANCED PROGRAMMING
Zone 1
SENSOR 1
Button [1]
SENSOR 2
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
This row :
Buttons for
Sensor 1
Zone LED :
Flash once
This row :
Buttons for
Sensor 2
Zone LED :
Flash twice
Erase Sensors
Proceed to the following to erase a sensor.
1
2
3
[PROG]
[MPIN] Enter
Programming
mode Enter master
password to
programming mode 3 beeps for valid password.
1 long beep for invalid
password.
[9] Select erase
remote
programming After [9] is entered, some
zone LEDs will flash or
stay off. The zone LEDs
represent whether that zone
is occupied by any sensor.
**See Table D below.
Refer to the table
below to select the
remote location. Select the
sensor you
would like to
erase After you have selected the
sensor, you will hear 3 beeps
and verbal confirmation
[Zone X Sensor Y Empty
Memory], where X and Y
are the zone and sensor
numbers you have selected. To erase an
occupied
sensor, press
[1] to [0].
ZONE LED DESCRIPTION
Off Zone is not occupied by any sensor
Flashes once This zone is occupied by sensor 1.
Flashes twice This zone is occupied by sensor 2.
Flashes once, This zone is occupied by sensors 1 and 2.
then twice
** Table D: Zone LED status for erasing sensors.
Step Keys Function Description Note
®
– 39 –