Saturn 2009 VUE Hybrid User Manual
Page 180
Using the Digit Dial Command
1. Press and hold
J
/
0
for
two seconds. The system
responds with “Ready” followed
by a tone.
2. Say “Digit Dial”. The system
responds with “Digit dial
using
the first digit to dial” followed
by a tone.
3. Say the digit to be dialed one at
a time. Following each digit, the
system will repeat back the
digit it heard followed by a tone.
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say “Dial”.
The system responds with “OK,
Dialing” and dials the number.
•
If an unwanted number
is recognized by the system,
say “Clear” at any time to
clear the last number.
•
To hear all of the numbers
recognized by the system, say
“Verify” at any time and the
system will repeat them.
Using the Call Command
1. Press and hold
J
/
0
for
two seconds. The system
responds with “Ready” followed
by a tone.
2. Say “Call”. The system responds
with “Call using
Please say the name tag”
followed by a tone.
3. Say the name tag of the person
to call.
•
If the system clearly
recognizes the name tag it
responds with “OK, calling,
the number.
•
If the system is unsure it
recognizes the right name tag,
it confirms the name tag
followed by a tone. If
the name tag is correct, say
“Yes”. The system responds
with “OK, calling,
the name tag is not correct,
say “No”. The system will ask
for the name tag to be
re-entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re-dial Command
1. Press and hold
J
/
0
for
two seconds. The system
responds with “Ready” followed
by a tone.
2. After the tone, say “Re-dial”. The
system responds with “Re-dial
using
the last number called from the
connected Bluetooth phone.
3-78
Instrument Panel