Shibaura CG161 - Manual (Page 35)

33
LUBRICATION AND MAINTENANCE
PTO SAFETY SWITCH ADJUSTMENT
If the engine will not start because the PTO safety
switch requires adjustment, adjust the switch as
follows:
1. Stop the engine and remove the starter key.
2. Remove the access panel.
3. Move the PTO clutch lever slightly toward the
“ON” position. This will release the switch
knob from the PTO clutch arm, Figure 52.
4. The safety switch knob is retracted by pulling
the PTO clutch lever to the “OFF” position.
Loosen the locknut, Figure 52. The safety
switch should be adjusted by screwing the
adjusting nut out or in so that the knob may
retract 1/5 in. (5mm) when the PTO clutch
lever is moved from the “ON” to the “OFF”
position.
5. After adjusting the switch be sure that it works
properly and tighten the locknut. If the clutch
lever does not move freely, lubricate the
clutch lever wires.
Figure 52 P.T.O. Safety Switch Adjustment
NOTE: When the engine cannot be started even if
the adjustments of brake pedal safety switch and/or
PTO safety switch have been made, con consult
with your RANSOMES Dealer.
TRACTOR STORAGE
Tractors that are to be stored for an extended period
should be protected during storage. The following is
a suggested list of operations to be carried out.
1. Thoroughly clean the tractor. Use touch-up
paint where necessary to prevent rust.
2. Check the tractor for worn or damaged parts.
Install new parts as required.
3 Lower the equipment hydraulically so the lift
piston 5 in a fully retracted position. This will
protect the piston surface from corrosion and
rust.
4. Lubricate the tractor. Drain and refill the
transmission, hydraulic system and rear axle
with new oil. Drain the engine oil and refill with
new lubricating oil. Also clean the air cleaner.
5. Remove the battery and clean it thoroughly.
Be sure that it is fully charged, and that the
electrolyte is at the proper level. Place it in
storage in a cool, dry place above freezing
temperature. The battery should be charged
periodically during storage.
6. Place blocking under the tractor axles.
7. Use the following storage procedure.
l
Before storing, the fuel system should be
flushed with a special oil, a quantity of which
will remain in the system when the engine is
shut down for storage.
l
Special diesel fuel system flushing oils are
available from most oil companies. If special
flushing oil is not readily obtainable, mix 0.24
litres of SAE 1 0 non-detergent engine oil 4.73
litres of No.2 diesel fuel.
l
Drain the fuel tank and pour two U.S. gallons
7.57 litres of the special flushing oil (or
lubricating mixture) in the fuel tank.