Swisher WB942 - Manual (Page 7)

SERVICE AND ADJUSTMENTS
BELTS CONFIGURATION
Stop engine, let all moving parts come to a complete stop. Disconnect spark plug.
TRANSMISSION BELT
BLADE SPINDLE
BELT
BLADE DRIVE BELT
BLADE SPINDLE BELT REPLACEMENT
REMOVAL
• Stop engine, let all moving parts come to a complete stop. Disconnect spark
plug.
• Remove belt cover.
• Remove Blade Drive Belt. (See Blade Drive Belt replacement.)
• Pull tension idler away from Blade Spindle Belt to relieve tension.
•
Remove belt.
INSTALLATION
• Pull tension idler away from belt.
• Install belt according to above configuration.
• Install Blade Drive Belt as shown.
•
Install belt cover and tighten hardware.
BLADE DRIVE BELT REPLACEMENT
REMOVAL
• Stop engine, let all moving parts come to a complete stop. Disconnect spark
plug.
• Disengage all blade controls by releasing the bails.
• Remove belt cover.
• Rotate belt off pulleys and pull belt through motor belt guide.
INSTALLATION
• Route belt as shown.
• Adjust engage idler tension. Belt should be snug during engagement of blade
latch. Too much tension will not allow the blade latch to function properly.
• Tighten nuts on blade engage cable when finished.
• Install belt cover and tighten hardware.