Silvercrest KH 2189 - Manual (Page 7)

- 5 -
Assembly
Before operating the device, make sure that it is in
a faultless condition. If it is not, it may not be used.
• Insert the plug into a power socket. Select a
power socket that is at all times easily accessible,
so that the plug can be quickly withdrawn in the
event of a malfunction.
Setting the clock
When you take the device into use for the first
time after inserting a new battery:
Whilst pressing and holding the button
TIME r :
• Repeatedly press, or press and hold, the button
HOUR t to set the hours.
• Release the HOUR t button as soon as the required
hour indicator is shown in the display s .
• Repeatedly press, or press and hold, the button
MIN. y to set the minutes.
• Release the MIN. y button as soon as the requi-
red minute indicator is shown in the display s .
The programmed time setting is automatically accepted
as soon as the button
TIME r is released.
Radio Reception
• Place the slider switch h at the position ON .
• Turn the volume regulator j to a midway position.
• Select the radio frequency range by using the
waveband selector FM/AM f .
• Now select the desired radio station by turning
the TUNING regulator g .
Note:
To improve reception in the FM frequency range,
slowly move and hold the end of the wire aerial
e
in various directions. When you have found the
best reception for the desired transmitter, fix the
wire aerial into this position e.g. with adhesive
tape. For the reception of AM transmitters, an aerial
is built into the device. For improved reception,
alter the position of the device in radio mode.
Setting the alarm time
When the correct time has been programmed in as
described above, proceed as follows:
Whilst holding the button
AL. ON o pressed down:
• Repeatedly press, or press and hold, the button
HOUR t to set the hours.
• Release the HOUR t button as soon as the required
hour indicator is shown in the display s .
• Repeatedly press, or press and hold, the button
MIN. y to set the minutes.
• Release the MIN. y button as soon as the requi-
red minute indicator is shown in the display s .
The programmed alarm setting is automatically
accepted as soon as the button
AL. ON o is
released.
Switching the alarm function on
If the clock and alarm time are set correctly, as
described above:
• Place the slider switch
h in the position AUTO .
The alarm is now switched on. Serving as a check,
a dot appears in the left of the display
s .
You will be woken by the radio if ...
• the volume regulator
j is placed at a sound
level at which you will be woken.
You will be woken by the alarm tone if...
• the volume regulator
j is engaged at the
position OFF/BUZZ.
IB_KH2189_DT35278_LB6 30.07.2009 8:54 Uhr Seite 5