Spectra Watermakers VENTURA 150 MPC-5000 - Manual (Page 11)

11
Gently fit the tube into the body and loosely thread on the nut.
Push the tube into the body until it bottoms out then hand tighten the nut.
DO NOT OVER TIGHTEN!
1/4" Tube Fitting Assembly
Install the Nut first then use the bevelled side of the Spacer to push the
Grab Ring onto the tube no more than 1/2". Slip the O-ring over the tube
to hold the Spacer in place. If the Grab Ring is pushed too far, trim back
the tube so about 1/4" of tube extends past the O-ring.
Step 4:
Step 3:
Step 2:
Step 1: Dissemble fitting components
Body
O-ring
Spacer
1/2" max
Grab Ring
Nut
Tubing
Product Tube Fitting Assembly