Sunbeam 7659 - Manual (Page 6)

Display mark Condition/Cause Corrective action
Mark in the Measurement in progress
surement condition and remain quiet.
Measurement in flashes when pulse is
progress detected.
Mark flashes when power is Automatic exhaust is
applied and there is air formed.
remaining in the cuff.
Exhaust
- -
A
Measurement has begun Raise
but the pressure was pressure 30-40
Insufficient insufficient. more and measure once
pressure
again.
Replace
batteries
Appears when the battery Replace all four batteries
voltage is excessively tow. with new ones.
error
Pulse error
Appears when the blood
pressure could not be
obtained accurately.
Appears when the pulse
rate could not be obtained
accurately.
Exhaust the air from the
cuff, and re-apply the cuff
properly and re-measure.
(Wait minutes before
re-measure)