beautypg.com

Specifications, General maintenance recommendations, Pressure washer maintenance – Snapper 020230 User Manual

Page 13: Before each use, Check and clean inlet screen, Check high pressure hose, Check chemical injection hose, Check gun and nozzle extension, Check in-line filter, Warning

background image

2650 PSI Pressure Washer

13

SPECIFICATIONS

Outlet Pressure . . . . . . . . . . . . . . . . . . . . . . . . . 2650 psi

Flow Rate . . . . . . . . . . . . . . 2.5 gallons per minute (gpm)

Detergent Use detergent approved for pressure washers

Water Supply . . . . . . . . . . . . . . . . Not to Exceed 100°F
Temperature

Automatic Cool . . . . . . . . . . . . . Will cycle when water
Down System reaches 125°-155°F

Shipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . .78 lbs.

GENERAL MAINTENANCE

RECOMMENDATIONS

The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.

NOTE: Should you have questions about replacing
components on your Snapper pressure washer, please call
1-800-317-7833 for assistance.

• Some adjustments will need to be made periodically to

properly maintain your pressure washer.

• All maintenance in this manual and the engine user’s

manual should be made at least once each season.

• Once a year you should clean or replace the spark plug,

clean or replace the air filter and check the spray gun and
adjustable nozzle extension assembly for wear.A new spark
plug and clean air filter assure proper fuel-air mixture and
help your engine run better and last longer. Please refer to
your engine user’s manual for more details.

• If equipped with inflatable tires, keep the air pressure at

the value marked on the tire or within 15 and 40 psi.

Before Each Use

1.

Check engine oil level.

2.

Check water inlet screen for damage.

3.

Check in-line filter for damage.

4.

Check high pressure hose for leaks.

5.

Check chemical injection hose and filter for damage.

6.

Check spray gun and nozzle extension assembly for
leaks.

7.

Rinse out garden hose to flush out debris.

PRESSURE WASHER

MAINTENANCE

Check and Clean Inlet Screen

Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.

Check High Pressure Hose

The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.

Check Chemical Injection Hose

Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either is damaged.

Check Gun and Nozzle Extension

Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by squeezing it and making
sure it “springs back” into place when you release it. Put
the trigger lock in the ON position and test the trigger.
You should not be able to squeeze the trigger.

Check In-Line Filter

Refer to Figure 13 and service the in-line filter if it
becomes clogged, as follows:

• NEVER repair high pressure hose. Replace it.
• Replacement hose rating MUST exceed maximum pressure

rating of unit.

The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.

WARNING

Nozzle Extension

Filter Screen

O-ring

Figure 13 — Clean In-Line Filter