Sony CHC-TB10 - Manual (Page 12)

12 GB
Presetting radio stations (continued)
Setting presets through
manual tuning
1
Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2
Press PLAY MODE/TUNING MODE
repeatedly until “AUTO” and “PRESET”
disappear.
When you use the remote in step 3, skip this
procedure.
3
Slide the knob to – or to + (or press
TUNING – or + on the remote)
repeatedly to tune in the desired
station.
4
Press TUNER MEMORY/DIRECTION (or
press TUNER MEMORY on the remote).
5
Slide the knob to – or to + (or press
PRESET – or + on the remote)
repeatedly to select the desired preset
number.
Preset number
6
Press ENTER.
The station is stored.
7
Repeat steps 1 to 6 to store other
stations.
Other operations
To Do this
Tune in a
station with a
weak signal Follow the procedure described in
“Setting presets through manual
tuning”.
Stop setting
presets Press TUNER MEMORY on the
remote.
Stop scanning Press x.
Change the
preset station Start over from step 1.
Change the
preset number Start over from step 1.
To change the AM tuning interval
(except for the European model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding
ENTER, turn the system back on. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the
same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power
failure occurs.
• To improve broadcast reception, reorient or move
the supplied antennas near a window or outdoors.