Sony VGN-FJ100 - Manual (Page 105)

105 n N
Precautions
On Using the Built-in MOTION EYE Camera
❑ Do not touch the front mirror plate over the lens of the built-in MOTION EYE camera, as it may make scratches on the
plate and such scratches will appear on the captured images.
❑ Do not let the direct sunlight get into the scope of the built-in MOTION EYE camera regardless of the computer's power
state, as it may cause a malfunction of the camera.
❑ The built-in MOTION EYE camera is disabled while videos or still images are imported from an i.LINK-compatible device
connected to the S400 (i.LINK) connector.
❑ Clean the front mirror plate over the lens of the built-in MOTION EYE camera with a blower brush or a soft brush. If the
lens is extremely dirty, wipe it off with a soft dry cloth. Do not rub the plate, as it is force-sensitive.
On Handling Floppy Disks
❑ Do not open the shutter manually or touch the surface of the floppy disk.
❑ Keep floppy disks away from magnets.
❑ Keep floppy disks away from direct sunlight and other sources of heat.
❑ Keep the floppy disk away from any liquid. Do not let the floppy disk get wet. When you are not using the floppy disk,
always remove it from the floppy disk drive and use a storage case.
❑ If the floppy disk comes with a label, make sure that the label is properly attached. If the edge of the label is curled up,
the label may stick to the inside of the floppy disk drive and cause a malfunction or damage your floppy disk.