Swisher LS67528S - Manual (Page 9)

1. Separate the components and identify. Note, the left hand light has the clear window
on the bottom. This is for the license plate illumination if needed
2. Un-tie and extend the wiring harness along the splitter. The Green & Brown wire go to
the right hand side as the unit is towed. The Yellow & Brown wire go to the left hand
side.
3. Note: a ground wire (White) is provided to assure proper grounding of the system.
4. Attach the mounting bracket as illustrated. (Page 11)
5. Before installing the lights, run the wires thru the large hole in the mounting plate.
Insert the brown wire in the “Tail” position and the Yellow or Green in the “Turn”
Position
6. Install the lights, right on the right side, left on left. Under one mounting stud install the
Ring terminal with the white wire. This will ground the light directly.
7. Use Wire Ties provided to tie the harness to the fender and splitter as needed
Light Kit Assembly Instructions
Green &
Brown Wire
Light Right Hand
(485) 10027
Yellow &
Brown Wire
Light Left Hand
(486) 10028
Amber Reflector
Each Side
Part No. 10031