Spalding M7900412 - Manual (Page 11)

11 05/06 ID# M7900412
Position rim assembly (1) 90 degrees to back bracket (13) as shown. Place inner-bracket (14)
over both carriage bolts (2) followed by springs (7), washers (8) and special nuts (26).
NOTE:
COMPLETED
ASSEMBLY
Tighten special nuts (26)
until flush with end of
carriage bolts (2)
as shown.
NOTE:
14
7
8
26
2
1
13
Do not over tighten as rim
will not flex properly. See
leveling instructions (Step
13) to determine how much
to tighten nuts (25 and 26).
NOTE:
Lower lower rim down. Holes in inner bracket (14) should line up with holes in backboard bracket
(13). If not, adjust special locknuts (25 & 26) until holes are aligned.
25
26
Align these
holes.
14
13
25
8.
9.