World area network (wan) – ST & T WCAM71 User Manual
Page 8

© 2003 ST&T Group. All rights reserved.
8
7. Click on your TCP/IP protocol then click on < properties >.
Under < Specify an IP address > enter the correct IP address and Subnet mask. Then
restart your Network connection.
9.
If your network is not connected to the Internet, you can use crosslink cable (RJ-45) that
comes within the package. Connect RJ45 cable between your computer and IP Camera
WCAM71. You will be able to view image through your browser by entering its IP address.
World Area Network (WAN)
IP camera WCAM71 only supports fixed IP and PPPoE. When using fixed IP, you must set
proper IP address, Mask address, Gateway address, and DNS address. You can also setting
ADSL PPPoE user id and password to connect to WAN.