Checking tire pressure, Checking fuel filter, Lubrication – Simplicity 1692969 User Manual
Page 18
CHECKING TIRE PRESSURE
Front tire pressure should be 12 15 psi (82 103
Rear tire pressure should be 10 12 psi (56 82
CHECKING FUEL FILTER
The fuel filter is
located
in fuel line between fuel tank and
carburetor. If filter is
dirty
or clogged, replace as follows.
Place a container below filter to catch spilled gasoline.
A
WARNING
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread hose
clamps further than necessary. Ensure clamps
grip hoses firmly over filter after installation.
1. Using a pliers, open and slide hose clamps from fuel
filter.
2. Remove hoses from filter.
3. Install new filter in proper flow direction in fuel line.
Secure with hose clamps. See warning at beginning
of procedure.
LUBRICATION
Lubricate the tractor as shown in figures 11 12. When
a grease gun is shown, wipe the fitting clean,
two
or three shots of lithium base automotive grease
Figure 11. Lubricating Tractor
(Simplicity part no.
and wipe off excess grease.
When an oil can is shown, wipe the area clean, apply a
few drops of oil (SAE
then wipe up drips or spills.
Figure 12. Lubricating Mower Deck
1 4