Stanton DIGIPAK PRO.V4 - Manual (Page 14)

14
JOG WHEEL SENSITIVITY
The touch sensitivity of the jog wheel can be adjusted to fit the needs and
feel of different users. When adjusting the sensitivity, be conscious of
extreme settings which may affect your performance. Setting the
sensitivity too high would engage the touch sensitivity with the hand just
above the wheel. Setting the sensitivity too low may not engage the touch
even while pressing firmly on the wheel.
To adjust the jog wheel touch sensitivity, press and hold the PITCH
BEND button while turning either encoder. Release PITCH BEND
when done. Wait at least 3 seconds before powering off the unit.
FACTORY SETTINGS
To return to factory settings…
Power off the unit.
Press and hold the CLEAR button as you power up the unit.
When the display reads clear ALL, release the CLEAR button.
WARNING: Restoring factory settings will delete cue point memory.
SLEEP
The C.324 will automatically go into sleep mode after 15 minutes of
inactivity. Press either the PLAY or CUE button to wake it up.
FADER START
By connecting the CD player to a mixing board that has the fader start
feature, the crossfader will engage playback or cue mode depending on its
location. If the CD player is connected to the left side of the crossfader,
playback will start once the fader is moved from the left most position
towards the right. The CD player will re-cue itself when the crossfader is
brought back to the left most position. Two CD players can be hooked up
in this fashion to work on both sides of the crossfader.
RELAY PLAY USING TWO PLAYERS
When both CD players are connected to each other via their FADER
START/RELAY jacks, the players can work in unison by playing tracks one
after another from both units.
Set both players to single play mode (the SINGLE indicator will be
illuminated in the LCD displays).
Begin playback on the first player.
When the first track ends, playback will automatically start on the
second player and the first player will automatically enter standby
mode.
When the track on the second player ends, the first player will play the
next track. The players will continue to perform continuous relay play
until stopped or until the last track is played.
You can set a cue point on the standby player to jump directly to that
point.
OPERATING INSTRUCTIONS C.324