Getting started, Insert sim card/battery – Siemens C62 User Manual
Page 9

Getting started
8
C62 en SUG, A31008-H6880-A1-1-7619 (17. September 2003, 15:10)
©
Siem
ens A
G
2002
, L
:\C
62_S
quirrel_(m
c)\en\sug
\von_
itl\C62_
Startup.fm
Getting
started
Insert SIM card/battery
The service provider supplies you
with a SIM card on which all the im-
portant data for your account is
stored. If the SIM card is in credit-
card size, snap out the smaller seg-
ment and remove any rough edges.
• Remove the battery cover by
pressing top centre of the cover
and slide downwards.
• Insert the SIM card into the slot
with the contact area facing down-
wards
and push gently until it en-
gages below the holder (make
sure the angled corner is in the
correct position).
• Place the battery into the block of
the phone, with the contact area
facing down. Push the battery
carefully downwards.
• Slide the battery cover upwards
from the bottom of the phone, un-
til it latches into place.
Note
Always switch off phone before removing
the battery!
Only 3 V SIM cards are supported. Please
contact your service provider, if you have
an older card.