Shoprider TE-889XLSN - Manual (Page 9)

12/8/2006 - 9 -
DRIVE/FREEWHEEL OPERATION (FIG 3)
The drive/freewheel lever is located next to the right rear wheel, under rear bumper. This
lever allows you to put the scooter in freewheel (neutral) and push the scooter. To push the
scooter while turned off, lift the lever in the up position (the scooter is now in freewheel).
To put the scooter into drive (in gear); put the lever in the down position (now the unit may
be driven).
Note: The scooter will not operate when the lever is up (in neutral). If the scooter is turned
on while the lever is up, you must turn the scooter off, put the lever in the down position,
and then turn the scooter back on.
WARNING! For safety, always put the scooter into gear (lever down) after pushing
or rolling scooter. Failure to do so may result in injury.
Shoprider® is not responsible for damage or injury incurred due to improper or
misuse of the scooter.
Freewheel
Release
Lever
Scooter
Serial
Number Anti-tip
Wheels
Figure 3