Shindaiwa HomePro 76RS - Manual (Page 2)

ASSEMBLY
Remove components from carton 1.
and place spreader upside down on
a padded surface. Install LH. & RH.
handle braces to frame as shown
using four (4) 1/4-20 x 2 1/4” hex
bolts and nuts but do not tighten.
Slide wheels onto end of axle with 2.
the hub facing toward frame. Wheels
are identical to ease assembly. Align
the hole in the wheel hub and the
hole in the axle as shown. Secure
drive wheel to axle with 3/16 dia x 2”
cotter pin. Insert 1/8 dia x 1 1/4” cotter
pin in the hole near the end of axle to
retain free turning wheel.
Turn spreader upright and install
3.
end of handle tube with DOT
between handle braces as shown.
Secure with (2) 1/4-20 x 1 1/2” hex
bolts and nuts.
RH. Handle
Brace
1/4-20
Hex Nut
LH. Handle
Brace
1/4-20 x 2 1/4”
Hex Bolt
3/16 Dia x 2”
Cotter Pin
Drive Wheel
1/8 Dia x 1 1/4”
Cotter Pin
DOT
Free Turning
Wheel
1/4-20 x 1 1/2” Hex
Bolt
1/4-20
Hex Nut
Handle
Tube