Smeg K400TL - Manual (Page 20)

5019 612 10059
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy
Label” refer to the programme “Cotton 60°C”.
1. Close the drum flaps and check that they are
properly locked.
2. Add detergents and additives into the dispenser
to no more then the “MAX“ level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the programme selector knob clockwise
to the desired programme.
4. Turn the temperature knob to the required
temperature.
“No spin” button
• Especially for delicate garments to avoid wear and tear
caused by the spin.
Note: with the “Cotton” and “Synthetics”
programmes a short spin cycle is provided in any case,
even if the exclusion has been selected, in order to
optimize rinsing results.
“Half Load” button
• Reduces the water consumption in the “Cotton” and
“Synthetics” programmes especially during the rinse.
• Especially suitable for lightly soiled or small loads
(reduces the quantity of detergent).
• Not suitable for high temperature programmes.
“Rinse Hold” button
• The laundry remains in the last rinse water,
without progressing to the spin cycle to avoid
creasing and prevent colours from changing.
• This option is especially recommended for the
“Synthetics” or “Delicate” programmes.
• This option is perfectly suitable if you wish to
postpone the spin or you don't wish to spin the
clothes.
Note: the programme selector stops on “ ”.
ENERGY AND WATER CONSUMPTION DATA
Programme Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
Cotton 90 5.0 72 1.80 115
Cotton 60 5.0 72 1.20 115
Coloured 60 2.0 60 0.80 100
Coloured 40 2.0 60 0.40 100
Quick Wash + 1/2 Load 40 2.5 54 0.50 85
Synthetics + 1/2 Load 30 1.0 54 0.30 70
Delicate 40 1.5 70 0.65 55
Wool 40 1.0 70 0.55 45
PREPARATION OF WASH CYCLE PRESS ANY DESIRED OPTION BUTTON(S)
Terminate the “Rinse Hold” option.
• Press the “Rinse Hold” button again; the
programme will terminate automatically with
the spin cycle corresponding to the previously
selected wash programme.
• If you do not wish to spin the clothes, switch off
the appliance by turning the spin speed knob to
the Off position. The pilot light goes out. Turn
the programme selector to the “Drain” position
and switch on the appliance.
Open the water inlet tap and press the “On/Off”
button. The pilot lamp lights up.
During the running programme, the door cannot be
opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical
power failure occurs, the door unlocks
automatically after about 1 minute.
• The programme selector knob is at “STOP”,
the pilot lamp lights.
1. Press the “On/Off” button . The pilot lamp
goes out.
2. Cancel the options by pressing the appropriate
buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload
the machine.
1. Press the “On/Off” button. The pilot lamp
goes out
2. Select the new programme, temperature and
options.
3. Press the “On/Off” button to switch on the
appliance. The pilot lamp lights up.
1. Press the “On/Off” button to switch off the
appliance. The pilot lamp goes out
2. Set the programme selector on “Drain”.
3. Press the “On/Off” button to to start the
“Drain” programme.
Only open the door when the programme
selector is at “Stop” and the door is unlocked
(after approximately 1 minute).
• After switching your washing machine on, it
does not start immediately: it needs some
seconds in order to lock the door, fill water and
then drum starts turning.
• Spinning has an interrupted start-up: the drum
starts and stops running several times, to
improve spin efficiency and to better balance
the laundry.
• At the end of the spinning cycle the drum goes
on reversing for some minutes: this helps you
unloading the laundry.
• Do not exceed in detergents dosage: excessive
foam formation may prevent spinning.
PROGRAMME START
DOOR LOCK
PROGRAMME END
SELECTING A NEW PROGRAMME, SPIN
SPEED, OPTIONS AFTER PROGRAMME
START
TO STOP, RESET A PROGRAMME BEFORE
THE END
NOTES AND INDICATIONS FOR USE