Shark TAPCLEAN EP035T2 - Manual (Page 4)

PRECAUTIONARY MEASURES
1. Do not operate the vacuum
cleaner to close too heaters,
or radiators.
2. Before inserting the power plug
into the wall outlet, make sure that
your hands are dry.
3. Do not vacuum any liquids.
6. Do not pick up anything that is
burning or smoking such as
cigarettes, matches or hot ashes.
7. Do not use without HEPA dust cup
filter in place.
5. When pulling out the power plug
from the wall outlet, pull the plug
not the power cord.
Important: If the suction opening in the unit or the hose become blocked, switch off
the vacuum cleaner and remove the blocking substance before you start
the unit again.
4. Keep hair, loose clothing, fingers,
feet and all parts of body away from
openings.
8. Before you start vacuuming,
make sure to remove large or
sharp objects that might
damage the vacuum.
3
OPERATING INSTRUCTIONS
Warning: Always unplug from electrical
outlet before opening the dust cup
(container).
Note : HEPA dust cup filter must be used
when operating the hand vacuum.
Using The Unit As A Hand
Vacuum
1. To open the dust
cup (container),
push button and
pull out the dust
cup. Verify that the
HEPA dust cup
filter is inside, then attach the
dust cup (container) to the
hand vacuum.
2. To use the Hand Vacuum with the
shoulder strap, attach it to the unit as
shown below.
How To Operate Your
Hand Vacuum
1. Hold the hand vacuum firmly in your
hand by the Handle.
2. Push the On/Off Power Switch to “On”
position.
3. Start vacuuming.
CAUTION: The Hand Vacuum is a
very powerful unit. Make sure that you
hold it firmly, otherwise it can slip out of
your hand and cause injury.
4
4. To use the flexible hose, push
the end of the hose into the
suction hole, then attach the
desired brush to the other end
of the flexible hose, as shown
below.
NOTE: When the Intelli-Sense Filter
Monitor TM lights up, it means that the
dust cup is full or filter needs cleaning.
You must empty the dust from the dust
cup and clean the HEPA dust cup filter
right away. (See illustration below.)
NOTE: The pet hair removal
attachment is for use on upholstery,
drapes and other fabric surfaces to
remove lint, pet hair, etc. THE PET
HAIR REMOVAL ATTACHMENT IS
NOT INTENDED TO BE USED AS A
PET GROOMING DEVICE.
3. To attach the oval brush or the pet
hair removal attachment to the
Hand Vacuum, push attachment
into the suction hole,
as shown
below.
Important: This unit is equipped with a
motor protective thermostat. If for some
reason the vacuum cleaner should
overheat, the thermostat will automatically
turn the unit off. Should this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of overheating
problem. (i.e. clogged hose or
filter)
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for
45 minutes, plug in the cleaner
and push the On/Off button. The
vacuum should start again.
• If the vacuum still does not start,
contact EURO-PRO at
1-800-798-7398.