Samsung 400EX(N) - Manual (Page 135)

→ , → [0~9]
• ID Setup
Assigns distinctive IDs to the SET.
• ID Input
Use to select the transmitter functions of the individual SET. Only a SET where the ID
corresponds to the transmitter setting becomes activated.
• MDC Connection
Selects a port to receive the MDC inputs from.
• Communicates with the MDC via a Serial MDC cable.
• Communicates with the MDC via an RJ 45 MDC cable.
• Network Setting
• IP Setting : Manual, Auto
• IP Address : Manually enter the IP Address if IP Setting is set to Manual.
• Subnet Mask : Manually enter the Subnet Mask if IP Setting is set to Manual.
• Gateway : Manually enter the Gateway if IP Setting is set to Manual.
MagicInfo
Available Modes
• PC
• AV
• Component
• HDMI
• MagicInfo
Note
For an EX model,
• MagicInfo can only be enabled when a network box is connected.
• The HDMI port and network box cannot be connected at the same time.
Note
• The remote control can be used to select MagicInfo. However, it is recommended to use
a separate USB keyboard to utilize MagicInfo fully.
• For MagicInfo in Device mode, moving external devices while booting may cause errors.
Set up external devices only if the LCD Display turns on.
Adjusting the LCD Display
92