Simaudio i 3.3 - Manual (Page 14)

MOON i 3.3 Integrated Amplifier
Remote Control Operation
The MOON i3.3 Integrated Amplifier uses the ‘CRM-2’ full-function remote
control (figure 5). It operates on the Philips RC-5 communication protocol and is
can be used with other Simaudio MOON components.
The ‘CRM-2’ remote uses two AA batteries (included). To install them, simply slide
the back plate off in the direction of the arrow; insert the batteries in the correct
direction and then replace the back plate.
To engage the ‘CRM-2’ remote for use with the MOON i3.3 Integrated Amplifier,
you must first press the button labeled AMP.
The POWER button located on the upper left will switch the integrated amplifier to
either ‘Standby’ or ‘On’ mode.
The DISPLAY button turns the front panel display on and off
The 2 buttons labelled ◄ INPUT ► allow you to sequentially scroll, either
backwards or forwards, through all six (6) available inputs. For example, to switch
from the “CD” to the “VIDEO” input you may press either
◄ INPUT three (3)
times or INPUT ► three (3) times. Pressing and holding down either of
these buttons results in only a single change to the selected input.
The 2 buttons labelled
▼ VOL ▲ allow you to control the volume level. Pressing
▼ VOL results in a decrease in the volume level; Pressing VOL ▲ results in an
increase in the volume level. You may either press and hold these buttons down or
press them briefly to make volume adjustments.
The MUTE button turns off the output volume. Pressing the “Mute” button a
second time will reinstate the output volume level back to its current setting.
Figure 5: CRM-2 Remote Control
____________________________________________________________________________________
Remote Control Operation 14