Siemens ET 97..UC - Manual (Page 4)

4
1. Hold down brackets
2. Clamping screws (4)
3. Sheet metal screws (4)
Setback Distance
Flat Area
Flat Area
Flat Area
After preparing cutout, remove shavings as they can affect the function of electrical
components.
d WARNING: To reduce the risk of ignition combustible materials surround the
installed cooktop are not permitted.
Solid surface countertops often require special installations. For example, heat
reflective tape and rounded corners may be necessary. Contact the countertop
manufacturer for instructions specific to your countertop.
The distance from the top of the cooktop to the bottom of cabinets above can be
reduced to 24" when the bottom of the wood or metal cabinet is protected by not
less than 1/4" (6.35mm) no. 28 MSG sheet steel, 0.015" (0.4 mm) thick stainless
steel, 0.024" (0.6 mm) aluminum) or 0.020" (0.5 mm) thick copper.
Parts included
Preparation
Countertop requirements
Cabinet requirements