Sound Performance Lab EQ MAGIX - Manual (Page 14)

14
Insert
Input
All microphones with balanced floating output, i.e. also microphones
equipped with tubes can be used when the phantom voltage is switched
on.
W WA AR RN NIIN NG G:: IItt iiss e esssse en nttiia all tto o ssw wiittcch h tth he e p ph ha an ntto om m ssu up pp pllyy o offff iiff o otth he err ttyyp pe ess
o off m miiccrro op ph ho on ne ess a arre e u usse ed d..
A A lliin ne e ssiig gn na all sso ou urrcce e o orr a an n u un nb ba alla an ncce ed d m miiccrro op ph ho on ne e m ma ayy o on nllyy b be e u usse ed d iiff
tth he e p ph ha an ntto om m ssu up pp pllyy iiss ssw wiittcch he ed d O OF FF F..
There is a switchable I NSERT path between the I NPUT stage and the
P ARAMETRIC stage. The signal can be fed to other sound processing units such
as compressors, limiters, de-essers or reverb units.
The I NSERT jacks at the rear of the EQ MAGIX are designed as unba-
lanced jacks for S END and R ETURN .
It is also possible to use the microphone preamplifier independently of
the P ARAMETRIC and V ITALIZER stages via the I NSERT , by feeding the micro-
phone signal out at the I NSERT S END jack, whilst feeding a second signal into
I NSERT R ETURN . This means that two independent signals can be processed
in the EQ MAGIX at the same time.
If there is no signal connected at the I NSERT jacks and the I NSERT switch is
activated, the microphone signal is maintained, as the signal flow is not
interrupted until there is a jack plugged into the S END and R ETURN jacks.
N
6