Stamina Products 4825 - Manual (Page 15)

15
COMPUTER INSTRUCTIONS
STORAGE
1.
2.
3.
4.
To store the Magnetic Recumbent 4825 Bike, simply keep it in a clean dry place.
Adjust the REAR FRAME(3) and FRONT FRAME(1) to the shortest position. The Magnetic Recumbent
4825 Bike is approximately 42 3/8 inches long x 26 3/4 inches wide x 31 3/4 inches tall. These dimensions
will vary. Please measure your Magnetic Recumbent 4825 Bike if exact dimensions are needed.
To move the Magnetic Recumbent 4825 Bike, lift the REAR STABILIZER(4) and use the WHEELS(49)
on the FRONT STABILIZER(2).
To avoid damage to the electronics, remove the batteries before storing the Magnetic Recumbent 4825
Bike for one year or more.
MAINTENANCE
The safety and integrity designed into the Magnetic Recumbent 4825 Bike can only be maintained when
the Magnetic Recumbent 4825 Bike is regularly examined for damage and wear. Special attention should
be given to the following:
Adjust the TENSION KNOB(25) and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise.
Verify that the WARNING LABEL(78) is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement WARNING LABEL(78) if it is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the Magnetic Recumbent 4825 Bike
removed from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the Magnetic Recumbent
4825 Bike.
Keep your Magnetic Recumbent 4825 Bike clean by wiping with an absorbent cloth after use. 1.
2.
3.
4.
5.
6.
7.
HOW TO INSTALL AND REPLACE BATTERY:
AA Batteries
1.
2.
Do not mix a new battery with an old battery.
Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
Rechargeable batteries are not recommended. 1.
2.
3.
NOTE:
Open the Battery Door on the back of the computer.
The computer operates with two AA batteries. Two batteries are
included. Refer to the illustration to install or replace the batteries.
OPERATION DESCRIPTIONS
To stop a running program, stop pedaling for 4 seconds to switch into STOP mode. In this mode, you can
move the pedals again to continue to run the current program, or you can press the SET button to select
a new program. The function values of DISTANCE and CALORIES will continue to accumulate.
When you complete a program, you can stop pedaling and press SET button to select a new program.
The function values of DISTANCE and CALORIES will continue to accumulate. This will allow you to run
several programs and still know the total DISTANCE and CALORIES during the workout.
If you want to restart with a new program, press and hold the MODE button down for two seconds to reset
all of the function values to zero. Press SET button to select a new program.
The computer will shut off automatically after 3 minutes of inactivity, and the function values, DISTANCE
and CALORIES, will be kept. 1.
2.
3.
4.