Using your esteem travel, Care and cleaning – Sunbeam HD1200 User Manual

Page 4

Using your Esteem Travel.

Always turn your hairdryer off at the power
outlet after use. Turn the power off and remove
the plug before cleaning.

Do not immerse your hairdryer in water or any
other liquid.

To clean the exterior, simply wipe over with a
dampened cloth and wipe dry.

Do not wind the power cord around the
hairdryer, as this may cause strain and damage
the wiring.

Before using your hairdryer
Squeeze excess moisture from your hair and
towel dry. Comb hair free of all tangles with a
wide tooth comb.

To operate your hairdryer
1. Fold the handle down away from the barrel

until it is in position.

2. Use a small coin to select the appropriate

setting on the voltage switch for the local
supply voltage either 230/240V or 100/110V.

3. Insert the 2 pin plug into a power outlet and

turn the power ON.

To dry your hair
1. Select the desired heat/speed setting - 2 for

fast drying or 1 for controlled styling.

2. Hold the hairdryer about 30cm away from

your hair to avoid burning your hair. Direct
the airflow towards your hair until it is dry.
Use the concentrator attachment to direct air
flow onto specific areas of hair for spot
drying or when styling.

Sunbeam is a registered trademark. Esteem is a registered
trademark. Made in China. Due to minor changes in design
or otherwise, the product may differ from the one shown
in this booklet. Approved by the appropriate Electrical
Regulatory Authorities. Backed by Sunbeam‘s 2 Year
Replacement Guarantee and National Service Network.

For more information or advice on any Sunbeam products,
contact the Sunbeam Consumer Service Line on 1800 025 059
in Australia. In New Zealand - contact the Sunbeam Office in
Auckland on 09 912 0747.

Care and Cleaning.