Washing instructions, Correct washing procedure – Ardo FLOI86E User Manual

Page 6

SM2632

WASHING INSTRUCTIONS

Detergent dispenser:

1 Prewash

Softener

2 Wash

Control panel:

A Prewash button

B No spin

C Turbo button

D Start button

E Programme selector knob

F Start / END LED

MODEL: FLOI 86 E

Before using the washing machine, make sure that it has been installed correctly as reported
in the instruction book.

Daily use

1. Before placing the washing in the washing machine, make sure that there are no hard pointed

objects in the pockets (nails, screws, coins, pins, stones, etc.) as these can damage both the
clothing and the appliance.

2. To improve the performance of the wash, place the washing loosely in the drum without

compressing it. Do not overload the machine. A full load of particularly absorbent material such as
bathrobes and towelling can unbalance the washing machine during the spin phase. The automatic
load-balancing system distributes the washing as evenly as possible and automatically sets the
best spin speed to reduce vibrations to a minimum.

3. Close the door, making sure that no washing has become trapped between the door and the

gasket.

4. Place the correct amount of detergent in the appropriate dispenser 2. When using a liquid

detergent, insert the partition supplied. If the Prewash function is required, add detergent to
compartment 1. Add softener to the compartment marked with the symbol . After adding the
detergent, gently close the detergent drawer.

Use knob I to select a wash programme suitable for the type of fabric, following the instructions
reported in the Programme Table.

6. Buttons A, B and C are used to select the extra functions. The options selected are indicated

by the relative LED’s. The duration of the wash cycle varies according to which options have been
selected.

7. To start the wash cycle, press the Start button D. After a few seconds, the fl ashing Start LED

will change to a fi xed light to indicate that the wash programme has started.

8. At the end of the wash cycle, the LED END will fl ash. Place knob I in the Stop position and

open the door to remove the washing.

9. The washing machine can be reset at any time by placing knob I in the Stop position.

CORRECT WASHING PROCEDURE