Senco PC0968 - Manual (Page 15)

14
TROUBLESHOOTING
PROBABLE CAUSE
Restricted air intake filter.
Defective (reed) valve.
REMEDY
Clean.
Drain air tank and measure pump up time. Compare to
specifications. If lower, remove pump head and inspect
valve plate, clean or replace.
Symptom 10. Air compressor not making enough air.
Symptom 11. Moisture in discharge air.
PROBABLE CAUSE
Condensation in air tank caused by high level
of atmospheric humidity or air compressor is
not run long enough.
REMEDY
Drain air tank after every use. Drain air tank more often
in humid weather and use an air line filter.
15
SPECIFICATIONS
Model # PC0968
Motor
Horsepower 1.5 (Peak)
Voltage 115
Amperage 8
Hz. 60
Phase Single
RPM 3450
Compressor Pump
Number of Cylinders 1
Compression Stage 1
Lubrication Lubeless
Crankcase Aluminum
Bearings Ball
Cylinder Aluminum/Steel Sleeve
Valves Reed-Single
Head Aluminum
Filter Insert
Motor/Pressure Switch Setting
Cut-out 120 PSI
Cut-in 90 PSI
Controls On/Off
Air tank
Capacity 2 gallon
Performance
CFM Air Displacement 4
CFM @ 90 PSI 2.2
Maximum Pressure 120 PSI
Pump-up Time: 0-125 PSI 68 sec.
Recovery Time: 90-120 PSI 15 seconds
Weight
Net 38 Ibs.
Dimensions
Basic LxWxH 16"x15"x13.5"