Sanitaire SC899 - Manual (Page 14)

How To Replace Worn Brush Strips
(anodized aluminum spiral)
New brush strip inserts are supplied in sets of two, one long and one short. To replace,
remove bottom plate and belt (see How To Change Belt). Then, grasp center of brush
roll and lift to remove.
A. Remove rubber end cap cover from one
end
B. Unscrew locknut
C. Remove end cap
D. Press down on the brush strip and push
out. Slide in new brush strip of same
length, clip first, until clip locks into place.
Replace second strip from opposite end.
(
double bristle brush roll requires two sets
of brush strips.)
When properly assembled, the brush roll should rotate freely between the two end
caps. Check the condition of the belt; change if necessary. Replace the brush roll, belt,
and bottom plate (see How To Replace A Worn Belt).
Ask for Genuine Eureka replacement brush strip.
12 inch–No. 52140; 16 inch–No. 52264
Order two sets for double bristle brush rolls.
14
A B C
CLIP
C. Position end cap so flat side of
center hole is over flat side of
threaded shaft
B. Tighten locknut
A. Align holes and secure rubber end
cap cover (flat side against end cap)
1
2
3
Headlight Bulb
(Standard on most models)
NOTE: Turn off the switch and unplug the electrical cord before replacing
headlight bulb.
Headlight style varies by model. Locate the notches that release the tabs at either (1)
top, (2) side, or (3) bottom of the lens, as illustrated. Place a screwdriver into one
notch; twist or pry the screwdriver to release the lens. Repeat for the second notch on
the opposite side.
Rotate the bulb socket forward. Push bulb in and turn to remove. Secure new bulb into
socket and rotate bulb socket backward.
Replace the lens tabs into the top or the bottom of the hood opening. Rotate lens to
position and press down at each notch until the lens locks into position.
NOTE: Use 25 watt replacement bulb, only.
Ask for GENUINE EUREKA replacement bulb, 40009A.
NOTE: Some models have two rows of bristles.