Philips Advance Têtes de brosse Sonicare - Manual (Page 9)

3 Press and hold the power button for 5 seconds.You will hear
1 beep if the Easy-start feature is off. If you hear 2 beeps,
Easy-start is active (on).
Using the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces Sonicare's effectiveness in removing
plaque.
The Easy-start feature should be deactivated when Sonicare is used in
clinical trials.
Smartimer\ 2-minute timer
◗ All Sonicare models come with the Smartimer feature, which
automatically sets the brushing time to the 2 minutes
recommended by dental professionals.
◗ If you wish to pause or stop brushing during your 2-minute cycle,
press the power button. Press the power button again and the
Smartimer will pick up where you left off.
◗ The Smartimer will automatically reset to the beginning of a
2-minute cycle if:
- brushing is paused for 30 seconds or longer;
- the handle is returned to the charger base.
Quadpacer\ 30-second interval timer (available on select
models).
C
◗ Quadpacer makes sure that you brush all sections of your mouth
evenly and thoroughly.At 30, 60 and 90 seconds, you will hear a
short beep and a pause in brushing action.This is your signal to
move to the next section of your mouth.
Recharge indicator battery charge status (available on
select models).
◗ If your Sonicare has a low charge, you will hear 5 beeps after you
have brushed your teeth for 2 minutes and the power button light
will flash rapidly.
When you hear the low charge indication, you have 3 or fewer
2-minute brushings left.
C
1 Place the handle in the charger base (with the Sonicare logo
facing towards you) to begin the recharging process.
◗ The power button light flashes slowly when the handle is in the
charger base to signal charging is in progress.
ENGLISH 9
1
2
4
3