Shark EP750ST - Manual (Page 4)

BATTERY PACK REPLACEMENT
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
HAND VACUUM WILL
NOT OPERATE
1. Batteries discharged.
2. No power in electrical
outlet supplying
transformer.
3. Unit needs servicing.
1. Charge unit.
2. Check fuse or breaker.
Replace fuse/reset
breaker.
3. Call:
US: 800-798-7398
Can.: 514-842-8691
HAND VACUUM WILL
NOT PICK-UP OR
SUCTION POWER IS
WEAK 1. Dust cup container is full.
2. Dust cup filter needs
cleaning.
3. Unit needs recharging.
1. Empty dust cup container
– (see page 4).
2. Remove dust cup filter
and check for object(s) in
air duct and remove.
Clean or replace dust cup
filter. (see page 4).
3. Charge unit.
DUST ESCAPING
FROM HAND
VACUUM
1. Dust cup container is full.
2. Dust cup filter is not
installed correctly.
3. Puncture/hole in dust cup
filter.
1. Empty dust cup container.
2. Review dust cup filter
installation instructions.
(see page 4)
3. Replace dust cup filter.
(see page 4)
HAND VACUUM
BRUSHES WILL
NOT PICK-UP
1. Extension tubes clogged.
2. Dust cup container is full.
1. Remove tube and/or
bushes. Remove
obstruction from tube or
brushes.
2. Empty and clean dust cup
container.
NOTE: If uncertain as to how to change your battery pack, we suggest
you take your vacuum to a reputable small appliance service
technician to have this service performed.
This vacuum cleaner is equipped with Ni-Cd batteries and you need to dispose of
them properly. When the batteries are no longer good for use, they must be
removed from the vacuum cleaner for disposal. Do not remove the batteries for any
reason other than disposal of them.
The battery pack of your EP750ST Is replaceable, however care should be taken when
doing so. Follow these steps when replacement is required:
1.
Open the battery compartment, by removing the single, Phillips head screw
located in the recess at the rear of the unit. NEVER open battery compartment
except to change the battery when required.
2. Remove battery compartment cover. Set aside battery compartment cover and
screw.
3. Carefully detach the two (2) electrical connectors from the battery pack by pulling
straight away from the battery.
4. Lift out old battery pack and set aside.
5. Insert new battery pack in battery compartment and re-connect terminals by
pushing lead wires onto battery tabs.
6. Tuck wiring inside battery compartment so that the wiring does not interfere with
the battery compartment cover when it is replaced.
7. Re-install the battery compartment cover by sliding it over the battery toward the
front of the unit, making sure that the front snap engages the body of the unit.
8. Replace the battery compartment cover screw.
CAUTION
• Use only with the battery pack supplied with the unit.
• Do not attempt to remove the battery pack from the unit to charge it.
• Never attempt to throw the battery pack or unit into a fire or incinerate it.
• Do not attempt to remove or damage the battery casing.
• Battery must be recycled or disposed of properly at the end of it's
service life.
BATTERY DISPOSAL
This vacuum cleaner contains a nickel-cadmium (Ni-Cd) batteries and must
be disposed of properly. Call your nearest recycling center for information on
the recycling and disposal of nickel-cadmium (Ni-Cd) batteries
6
WARNING: NEVER use ordinary batteries for replacement, as these
may leak and damage your vacuum cleaner.
CAUTION: NEVER use the unit without the battery compartment cover
in place.
7