Sharper Image EVSI-HTR70 - Manual (Page 6)

10
Using the Remote Control
Battery Installation
One CR2032 3V battery is included with the remote control. To activate the remote
control functions, pull out the plastic pull tab protruding from the remote control
housing. To change the battery, remove the battery drawer at the bottom back
of the remote by squeezing the side and pulling the drawer out. Please insert the
battery into the remote with the positive side up as shown on the drawer.
NOTE: Always keep the battery and remote control out of the reach of children.
Remote Control Features
• Only use CR2032 3V battery with this remote control.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc) batteries.
• Batteries may pose a choking hazard. Do not let children handle batteries.
• Clean the battery contacts and also those of the device prior to battery installation.
• After opening battery door, be sure the door is properly closed and clicks shut.
• Remove used batteries promptly. Dispose of used batteries immediately.
• If the unit is not going to be used for a long period of time, remove batteries to
prevent damage due to possible battery leakage.
• Please dispose of used batteries per local regulations.
+
CR2032
PRESS
PULL
3V
Bottom of Remote
Power ON/OFF Heat Settings
Oscillation ON/OFF Timer Settings
11
Cleaning and Storage
We recommend that the heater be cleaned at least once a month and before
off-season storage.
• Turn the heater OFF at the main switch and unplug it. Allow it to cool.
• Use a dry cloth to clean the external surfaces of the heater.
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION
• Clean your heater using the above-mentioned steps, then disassemble and
pack the heater in its original container and store it in a cool, dry place.
• The motor is factory lubricated and will require no further lubrication.
Air Filter
• Dirt and dust may be caught on the air filter, affecting the function of the device.
Clean the air filter regularly.
• To clean, turn unit OFF and unplug unit from outlet, then remove the Back Grill
Cover on the back of the heater. Remove the air filter from the grill.
• Wash the filter by hand in a lukewarm solution of water and detergent. Rinse the
filter in clean water and allow it to dry thoroughly. Place the clean, dry filter back
into the back grill and close the back grill cover.
• Do not use the device without the filter and back grill cover secure.
Troubleshooting
If the Heater Fails to Operate
• Be sure it is plugged in and that the AC outlet is working. Check circuit breaker
in case of a blown circuit.
• Check for any obstruction. If you find an obstruction, press ON/OFF main switch
to turn the heater OFF. Unplug the heater and wait at least ten minutes for it to
cool. Carefully remove the obstruction. Plug the heater back in and restart it as
described under OPERATING INSTRUCTIONS.
• If the heater still does not operate, remove the power cord from the AC outlet
and have the heater service by authorized SI product service personnel.