Sharp MD-MX20 - Manual (Page 26)

25
■ Recording from the built-in radio onto a
MiniDisc
1
Tune in to the desired station (pages 19 - 20).
2
Load a recordable MiniDisc.
3
Press the ● REC button.
● The unit will enter the recording stand-by mode.
4
Check the recordable time by pressing the DISPLAY
button.
Notes:
● Before recording an AM broadcast, enter the recording
stand-by mode, and then separate the AM loop antenna
from the main unit. Adjust it so that the AM broadcast can
be tuned in most clearly.
● During recording, you cannot change the station.
5
Press the MD
06 06 06 06 06
button.
(Continued)
5
4
3
2
4
3
5
MD ■
MD ■
To stop recording:
Press the MD ■ button.
The recording will stop and the track number will be written
on the MiniDisc.
To record the track number while recording:
The recording is performed as a single track.
To identify different sections of a recording, you can increase
the track number at any point during the recording process.
To create a new track number while in the recording mode,
press the
● REC button.
● The track number will increase by one, and then the re-
cording will continue.