Woodstock M1113 - Manual (Page 17)

-15-
M1113 18" Wood/Metal Bandsaw
SE
TU
P
Figure 13. Rear fence rail attached to
table.
Figure 15. Front fence rail attached.
10. Insert the rail bracket knobs through the front fence
rail brackets, then thread the T-nuts onto the ends
of the knobs a couple of turns.
11. Slide the front fence rail T-slot over the T-nuts, as
shown in Figure 15, then position the front fence
rail brackets even with the rear fence rail, and
tighten the knobs.
Figure 14. Rail brackets attached to table.
Rail
Brackets
9. Attach the rail brackets to the front of the table
with the two M6-1 x 16 cap screws, as shown in
Figure 14.
8. Attach the rear fence rail to the backside of the
bandsaw table with two M6-1 x 6 cap screws, as
shown in Figure 13.
Figure 16. Installing fence onto rails.
12. Pull the fence handle up and place the fence on the
front fence rail, as shown in Figure 16.
13. Slide the fence against the blade.
Rail Bracket Knobs