Woodstock W1822 - Manual (Page 17)

-15-
Model W1822 (For Machines Mfg. Since 9/10)
O
PE
R
ATIO
NS
Blade
Workpiece
Figure 21. Example of miter cutting with
the fence positioned 45° to the left.
Miter Cutting
Blade
Workpiece
Figure 20. Example of miter cutting with
the fence positioned 45° to the right.
The crosscut fence can be positioned for miter cuts
between 50° the left and 50° right.
To perform a miter cut, do these steps:
1. DISCONNECT SAW FROM POWER!
2. Position the fence at the rear of the sliding table
and at the correct angle, then lock it in place (see
the example illustrations in Figures 20– 21).
3. Position and secure the extension table and
extension fence to provide the optimum support for
the workpiece.
4. Mount the workpiece flat on the tables and firmly
against the crosscut fence.
5. Turn the saw ON, firmly hold the workpiece on the
tables and against the fence, then push the fence
and sliding table forward to pass the workpiece all
the way through the blade to make the cut.
6. Turn the saw OFF, then remove the workpieces.