beautypg.com

Schumacher ProSeries 94080025 User Manual

Page 2

background image

NOTE: A fully charged battery will read 100%

5. Recharge the jump starter after use and every 3 months to full

charge status to extend the battery’s life.

If the charger is plugged in for over 48 hours and the battery(s) do

not fully charge in this time, CHG ERR is shown on the Display. The

batteries may be getting old and will no longer accept a charge.

to order and replace Jaws

Part Number

Description

QTY Per

Clamp

0099000680

ToP BATTERY CLAMP JAW

1

0099000705

BoTToM BATTERY CLAMP JAW

1

3899001640

BRAIDED CABLE

1

5199000636

SCREW, JAW To CLAMP

2

5199001010

SCREW, JAW To CABLE

1

limited warranty

Schumacher Electric Corporation warrants your unit to be free from defects in material and workmanship, excepting abuse or misuse, for a

period of one year from the date of sale to the original user or consumer purchaser. If your unit fails or malfunctions within the first 30 days

of the warranty, we will replace it with a new unit. If your unit malfunctions or fails within the 12 month warranty period because of a defect in

material or workmanship, we will repair without charge.
The internal battery, excluding units with swollen batteries or melted battery terminals, carries a 90-day warranty from the date of purchase.

Proof of purchase required. All battery replacements will be at the sole discretion of the manufacturer or his designated agents.
This warranty is in lieu of all other express warranties. The duration of any implied warranty, including but not limited to any implied warranty

of merchantability or fitness for a particular purpose, made in respect to your unit is limited to the period of the express warranty set forth

above.
For warranty service, return your product, with proof of purchase, to the factory or a designated agent: Schumacher Electric Corporation

Warranty Service Department, 1025 E. Thompson Street, PO Box 280, Hoopeston, IL 60942. Phone 1-800-621-5485, Customer Service

hours: 7 AM to 4 PM CST.
You will be responsible for all insurance and freight or other transportation charges to the factory or point of repair. We will return your unit

freight prepaid if repair is covered under warranty. Your unit should be properly packed to avoid damage in transit, since we will not be

responsible for any such damage.
In no event shall Schumacher Electric Corporation be liable for consequential or incidental damages. Some states do not allow limitations on

the length of the implied warranty or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions

may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.

Send Warranty Product Repairs to: Schumacher Electric Corporation

1025 East Thompson, Hoopeston, IL 60942-0280

Call Customer Service if you have questions: 1-800-621-5485

CoNTAINS SEALED NoN-SPILLABLE LEAD-ACID BATTERY. MUST

BE DISPoSED of PRoPERLY.
WARNING: Possible explosion hazard. Contact with battery acid may

cause severe burns and blindness. Keep out of reach of children.

Battery Clamp Jaw Replacement

1. Secure clamp in open position using a vise or equivalent clamping

device.

IMPORTANT: Make sure the rotary switch on the front

panel is in the o (off) position and the jump starter is not

plugged into a 110V AC electrical wall outlet.

2. Unscrew fastener securing the cables to the rear of the top

jaw.

3. Unscrew fasteners (2) securing the Copper Jaws to the plastic

clamp. Remove the jaws and braided cable.

4. Reverse for assembly.

storage

The jump starter can be stored in any position. When the rotary

switch is in the 12V position, (or, for Model PSJ-4424, 12V or 24V)

the clamps are live and will produce arcing or sparking if they come

in contact with each other. To prevent accidental arcing, always keep

the clamps in the compartments and the switch in the off position

when not using it to jump start a vehicle.
All batteries are affected by temperature. The ideal storage

temperature is at 70 degrees fahrenheit. Performance varies based

on battery temperature conditions.

dsr professional products

Schumacher Electric Corporation

801 Business Center Drive, Mount Prospect, IL 60056-2179