Soundstream Technologies woofer - Manual (Page 2)

Congratulations and thank you for purchasing Soundstream products. We are confi-
dent you will enjoy your new subwoofer and appreciate the effort involved in bringing
you the best engineered and crafted subwoofer in this category. Harmonic
indulgence...Listen and feel.
We advise you to keep this manual in a safe and dry place. Write down any important
information to reference from in the future, such as all of your enclosure information.
Draw a simple diagram and write all the parameters of the enclosure incase you ever
need to reference from it in the future.
The following enclosure recommendations are only a few in variation of what the
woofer requires. If you need specific information for a design and have questions
regarding it, please contact our Technical Support Department with your details, via
email at [email protected]. We strongly suggest you use or build an
enclosure with in the following parameters for proper function and quality results from
your woofer. Building an enclosure too far from the specified suggestions may cause
undesired performance and/or damage to your woofer and in some cases your
amplifier as well.
Specifications
NOTICE
* These numbers are measured with the cosmetic rubber gasket in place. Please measure the driver
yourself for precise dimensions or if necessary with out the gasket.
Sealed Enclosure Recommendations for R1-12
Optimum Enclosure Other Enclosure Recommendations
MAX Power Volume
Model
Mounting Depth
Outer Diameter
Cutout Diameter
Driver Displacement
Impedance
RMS Power
MAX Power
PEAK Power
Voice Coil
Magnet Weight
Frequency Response
Resonant Frequency
Qts
Qms
Qes
Vas
XMAX
SPL
R1-15
*8.75”
*15.625”
14.25“
.2 cu. ft.
Dual 4 ohm
900 watts
1300 watts
2600 watts
3”
250 oz.
29 - 400Hz
27.951Hz
.680
4.453
.803
98.539 ltr
10 mm
86.2 dB
R1-12
*7.5”
*10.375”
11.125”
.15 cu.ft.
Dual 4 ohm
800 watts
1200 watts
2400 watts
3”
250 oz
28 - 400Hz
26.795Hz
.629
5.260
.714
52.372 ltr
10 mm
83.4 dB
NET Volume 1.1 cuft / 31 ltrs
Enclosure Q .8
Max Power 800 watts
Fill 50% Medium
All volume suggestions are “Net Volume” before any
displacement. Please add accordingly to your design
NET Volume 2 cuft / 56.7 ltrs
Enclosure Q .6
Max Power 800 watts
Fill 50% Loose
All volume suggestions are “Net Volume” before any
displacement. Please add accordingly to your design
Smallest .75 cuft / 21.2 ltrs 700 watts
Largest 2 cuft / 56.7 ltrs 800 watts
MAX Power Volume
Smallest 1.4 cuft / 39.6 ltrs 700 watts
Largest 3 cuft / 85 ltrs 750 watts
Sealed Enclosure Recommendations for R1-15
Optimum Enclosure Other Enclosure Recommendations
NET Volume 2.2 cuft / 62.3 ltrs
Vent Design 4” X 11.25”
Tuning Freq 34Hz
Max Power 800 watts
All volume suggestions are “Net Volume” before any
displacement. Please add accordingly to your design
Vented Enclosure Recommendations for R1-12
Optimum Enclosure Other Enclosure Recommendations
NET Volume 4 cuft / 113 ltrs
Vent Design 30 sqin X 14.5”
Tuning Freq 32Hz
Max Power 800 watts
All volume suggestions are “Net Volume” before any
displacement. Please add accordingly to your design
NET Volume 3.5 cuft / 99 ltrs
Vent Design 35 sqin X 17.5”
Tuning Freq 34Hz
Max Power 800 watts
All volume suggestions are “Net Volume” before any
displacement. Please add accordingly to your design
Vented Enclosure Recommendations for R1-15
Optimum Enclosure Other Enclosure Recommendations
NET Volume 5 cuft / 142 ltrs
Vent Design 40 sqin X 15”
Tuning Freq 32Hz
Max Power 800 watts
All volume suggestions are “Net Volume” before any
displacement. Please add accordingly to your design
Wiring Configurations
There are a variety of impedance possibilities when using woofers equipped with
multiple coils. It is “EXTREMELY” important that ALL coils are used and none are left as
spares. Always provide the minimum impedance your amplifier requires. If you need
assistance with wiring configurations, please consult a professional installer or
contact our Technical Support Department with your questions.