Sealife DC250 - Manual (Page 53)

53
EE
AUTO POWER OFF
If there is no camera activity (no buttons are pressed) for a defined period of time
while the camera is powered on, the camera will switch to an idle mode, and
eventually turn itself off to conserve power.
Inactivity period Inactivity period Camera status
(batteries) (AC power adapter)
90 seconds 90 seconds stay idle
3 minutes 30 minutes shut off
If the camera is idle, re-activate the camera by pressing any button or switch the
mode dial. If the camera has powered-off you must to turn the camera on again
by pressing the
button. The table (above) shows the default time settings for
idle, and power-off. You can change the power saving interval by using the /
button and then press the OK button.
[3 min], [5 min], [10 min], [30 min]
RESET TO DEFAULT
If you wish to restore all camera settings to their original status, select [YES] by
using the /
button and then press the OK button.
The following table shows the default setting for each item.
Item Description
Image resolution 1600x1200 pixels
Image quality Fine
Flash Auto
Quick view On
White balance Auto
EV compensation 0.0
Slide show delay 4 seconds
Auto power off Battery: 3 minutes
AC power adapter: 30 minutes
Sound On
Digital Zoom Off
LCD monitor On