Sherwood ST-3103 - Manual (Page 5)

Troubleshooting Guide
4
Specifications
Component
No Power
No sound
Distorted sound
Less bass and poor
imaging
The AC input cord is disconnected.
The POWER switch on the rear panel is
not pressed.
Incorrect connection between the
components.
Incorrect operation of the component
connected.
The unit runs at excessively high volume
level.
The PHASE switch is set to the opposite
position.
Connect the cord securely.
Press the POWER switch to ON.
Make connections correctly.
Operat the component correctly.
Decrease the volume level or adjust the
corssover frequency.
Set the PHASE switch correctly.
PROBLEM POSSIBLE CAUSE REMEDY
ASW-158
Frequency Response 60~20KHz
Power, 35Hz, Impedence 6 80 W
Sound Pressure Level 86dB/W/m
Power Supply 230V/50Hz
Power Consumption 75W
ASW-138
RMS Power 50W
Max Power 80W
Impedence 6
Power Pressure Level 86dB/W/m
ST-20
RMS Power 35W
Max Power 70W
Impedence 6
Power Pressure Level 86dB/W/m
Note : Specifications are subject to change without notice.
If this unit does not perform as expected, consult the table below to see if the problem can be corrected before
seeking help from your dealer or our service organization.
ST-3103 : ASW-138 1Pcs, ST-20 5Pcs
ST-3108 : ASW-158 1Pcs, ST-20 5Pcs