Shindaiwa X7502825900 - Manual (Page 21)

21
Long Term Storage
Remove the spark plug and pour about 1/4 ounce of 2-cycle mixing oil into the cylinder through the spark plug hole.
■
Slowly pull the recoil starter 2 or 3 times so oil will evenly coat the interior of the engine. Reinstall the spark plug.
Before storing the unit, repair or replace any worn or damaged parts.
■
Remove the air cleaner element from the carburetor and clean it thoroughly with soap and water. Let dry and reassemble
■
the element.
Store the unit in a clean, dust-free area.
■
Whenever the unit will not be used for 30 days or longer, use the following procedures to prepare it for storage:
Clean external parts thoroughly.
■
Drain all the fuel from the fuel tank.
■
IMPORTANT!
Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is
added.
1. Prime the primer bulb until no more fuel is passing through.
2. Start and run the engine until it stops running.
3. Repeat steps 1 and 2 until the engine will no longer start.
CAUTION!
Gasoline stored in the carburetor for extended periods can cause hard starting and could also lead to increased service
and maintenance cost.
Remove the remaining fuel from the fuel lines and carburetor.
■
Loading Trimmer Line
Cut one piece of line to recommended length. 1.
Align arrows on top of knob with openings in eyelets. 2.
Insert one end of trimmer line into an eyelet, and 3.
push line equal distance through trimmer head.
Hold trimmer head while turning knob clockwise to
4.
wind line onto spool until about 5” (13 cm) of each
line remains exposed.
Trimmer head is now fully loaded and ready for
operation.
.080 (2.0 mm) dia. - 20’ (6 m)
.095 (2.4 mm) dia. - 14’ (4 m)
.105 (2.7 mm) dia. - 10’ (3 m)
1 2
3 4