Southbend GB/15PC - Manual (Page 45)

M ARATHONER G OLD & S ILVER S TAR G AS C ONVECTION O VENS
T
ROUBLESHOOTING
O PERATOR ’ S M ANUAL 1181887 REV 1 P AGE 45
TROU
BLE
S
H
OOTI
N
G
BLOWER WHEEL REPLACEMENT
To replace the blower wheel, do the following:
1. Remove racks and rack guides.
2. Remove rear air baffle in front of blower wheel.
3. Loosen the two square heads on blower wheel hub.
4. Pull blower wheel from motor shaft. If blower wheel is difficult to pull off, use puller disk (available from
Southbend Technical Service Department as part number 1179100).