Sangean DT-200V - Manual (Page 5)

The battery cover is located on the back of the unit.
Slide the cover in the direction of the arrow to gain
access to the battery compartment(12). Insert 2
AA batteries into the compartment(12). Make sure
that the batteries are positioned in accordance with
the diagram located below batteries in battery com-
partment. Replace cover.
BATTERY INSTALLATION
NOTE:
(1) A flashing "E" appearing on the LCD
Display indicates a weak battery and
replacement is necessary
(2) To ensure that the preset memories are
not lost during the battery replacement,
two steps must be followed . Make sure
that the power ON/OFF switch is in the
"OFF" position and the battery
replacement is completed within one
minute . If these two steps are not
accomplished , the memory will have to
be reset
5